野马Mach 1雾灯支架模型

Mustang Mach 1 Foglight holders

2024-05-08 09:42:47

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Created these to install a pair of fog lights into my 2022 Mustang Mach 1 grille.

The rings clip into the place where the grille inserts are (replace the inserts) on the Gen 6 Mach 1.

The clamps bolt through the top of the rings and the flat bit rests on top of the flat surface on the top of the grille aperture. Add VHB tape to this for extra strength.

Drill guide is to convert a single bolted fog light clamp to two bolt pattern. For the clamp you may need to remove some of the metal to not interfere with the top grille clip.

NOTE - This will need bumper removal to install

Lights used: -
https://www.amazon.co.uk/dp/B08SBLZLWK?ref=ppx_yo2ov_dt_b_product_details&th=1
(not affiliated)

Link to more details:-
https://www.mustang6g.com/forums/threads/mach-1-fog-light-install.201099/

Print Settings

Printer brand:
VoronDesign
Printer:
Voron2 350
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
80%
Filament brand:
AMZ3D
Filament color:
Black
Filament material:
ABS
Notes:
Used 80% infill with 1.6mm wall / top / bottom layer as wanted this very strong.

Post-Printing

Shaping

As there is a slight curve top to bottom of the grille apature you will need to put a slight top to bottom bend in the piece. Do this while the piece is still warm from printing (or heat up post print).