10ml注射器活塞

Summary

This was designed primarily for use with syringes of soldering flux, which typically come in 5ml, 10ml or 30ml syringes. The standard plungers with a rubber bottom will trap air in the syringe, resulting in way more flux being dispensed than desired. This syringe is designed to stay in place, without trapping air inside the syringe tube.

Print Settings

• Printer brand:

  Creality

• Printer:

  K1

• Rafts:
  No
• Supports:
  No
• Resolution:
  0.2mm
• Infill:
  20%
• Filament brand:

  eSUN

• Filament color:

  White

• Filament material:

  PLA+

• Notes:

  There are very small tolerances with this model. Too small and it falls out of the syringe, too big and it won't fit. If anything, it's probably better for it to be a little too big, and sand down the tip a little until it fits.

  Given the height and the small base area, it may be necessary to print with a brim.