SEMTO FS-L200AC 3D模型实验用固定件和配件

SEMTO FS-L200AC Experimental Mounting Bits and Bobs

2023-05-12 03:51:41

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This thing is a collection of a few experimental (I’m still trying to get the engine running properly myself – so please note these bits have not been tested for a long run yet) bits and bobs I printed to use with SEMTO FS-L200AC model engine. There are 3 images included showing what each STL is.

For the Hall Screw Mount (part 3 of 3) please note in the image you will see I have cut this in half as I ran out of adjustment so I’m currently only using one screw. I have yet to design a mount that gives me enough adjustment with 2 screws.

The small and large mounts may need a bit of rubber or similar under them to make them tight enough.

I have printed it out of PLA, the main engine mount has some short pieces of fuel tubing separating the engine from the PLA. I have not been able to make the engine run for long enough yet to know if the PLA will get too hot and melt – so something to watch out for if you give it a go!

Print Settings

Rafts:
No
Resolution:
0.2
Filament brand:
BasicFil
Filament material:
PLA
Notes:
I did use supports on the middle of the Hall effect sensor curved mount (part 1 of 3)