修改后的车架（用于DartZone Max Stryker泵手柄）

Modified Carriage for DartZone Max Stryker Pump Grip

2023-03-26 15:25:41

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

This is a modified carriage for Wporterfield's DartZone Max Stryker Pump Grip https://www.thingiverse.com/thing:4938263, which is itself a modified Nexus Pro Pump Grip https://www.thingiverse.com/thing:4624588 by haphazardlynamed

The original Stryker pump grip only would prime fully if a breech spacer was incorporated into the blaster, as otherwise the grip wouldn't have enough backward room to prime. This modified grip carriage (to replace the one that the stryker grip would usually attach to) moves the faux-picatinny attachment point forward roughly a centimeter so that the foregrip can move backward far enough to click the mechanism.

The carriage uses the same two factory screws that you would normally insert into the default carriage, but you may need to drill the screw receptacle holes a little bigger to accomodate.

Before you leave the printed carriage in the blaster for a decent length of time, sand the part of the carriage that is touching the buildplate down a little. If you're using PLA the carriage will swell a little over time and may get stuck to the foregrip, which is what happened before I took the thingiverse photos. Sliced clean into two fingers trying to remove the thing.

修改后的车架（用于DartZone Max Stryker泵手柄）

朋友，你觉得上面这个模型，属于下面的哪个分类？