B&G战术部件

B&G Tactical parts

2023-06-25 02:39:47

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A few "Tactical" parts I made for my pest control friends. All parts were designed to fit a B&G wand with 10mm diameter with the 15mm diameter end. (May fit AIrofog and similar as well but have not been tested)

Current Parts:

Crosshair: Fun esthetic piece made to fit the end of the wand. I printed it with no infill, no top and bottom layers and thicker walls, can be printed with infill and top/bottom layers.
Simple Clip: Designed to fit on main portion of wand, I have 3 current sizes and can make more if requested/necessary. Current Sizes are 30mm, 25mm and 22mm. 30mm was designed for 1-1/8 to 1-3/16 (May fit 1-1/4") handled lights such as the Streamlight Striker/Stinger. 25mm should fit 1" handles such as the NightStick TAC560xl, and OLIGHT Baton 3. 22mm is for small (3/4")tactical lights such as the Streamlight ProTac 1L.
Offset Clip: Designed to fit near the tip of wand, offset is to move the lens of the light away from the tip. I have 2 current sizes and can make more if requested/necessary. Current Sizes are 30mm, and 25mm. 30mm was designed for 1-1/8 to 1-3/16 (May fit 1-1/4") handled lights such as the Streamlight Striker/Stinger. 25mm should fit 1" handles such as the NightStick TAC560xl, OLIGHT Baton 3 etc.

All test prints done with .8mm nozzle, If you are printing with .4mm nozzle, you may need to print with infill or double up wall count. For example, I printed without infill and 4 walls, no top/bottom layers. With a .4mm nozzle you'd need 8 walls.

Non-Commercial. Feel free to print for your own use however you cannot sell these without consent.