亚马逊基础自动化垃圾桶更换连动齿轮

Amazon Basics Automatic Bin Replacement Hinge Gear

2023-07-22 18:19:02

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I don't know if anyone else has had this problem with the Amazon Basics Automatic, motion sensor bin lid, where the drive gear breaks. I might be the only one, but if I'm not, I hope this helps at least one other person out there.

I have found that the little plastic drive gear that connects the hinged lid to the motor is a weak point in the product design. When this gear breaks (happened twice to me now), the bin no longer automatically opens or closes. Replacing the bin is very expensive for the sake of a tiny cheap part, so I have created a printable replacement.

To replace the gear, you will need to open up the bin lid by removing the casing screws. Then locate the motor and gearbox assembly (see photo) and remove the 4 anchor screws to free it. Once that is out of the way, replace the hinge gear with your 3d printed part, using the two screws. Rebuild and bingo bango bongo, a working bin lid.

NB: Be careful not to damage the encoder fins on the back of the motor, they are quite fragile. Also, remember to turn your bin lid off before opening it up.

I print this at 100% infill for strength at 0.15 mm layer height. It takes about 30 mins.