壁挂式纸巾架

Wall-Mounted Paper Towel Holder

2023-07-24 17:42:04

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发货），感谢理解带宽压力

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

My design is on Onshape if you want to mod it. I added 0.3mm clearance for tight interference fits; change that variable if your printer is better.

PARTS:

Stiff tension spring: MAX 4mm diam. x 40mm long, MIN 2mm x 20mm. I used one that was 2.7 x 26 (0.4mm wire). Alternately, O-ring might work as elastic.
1" (25.4mm) wooden dowel cut to 11" (28cm)
2x M3 x 16mm
1x M2 x 16
3x M2 x 12
2x 1" (25mm) long flat head wood screws
2x 1.5" (40mm) long flat head wood screws

PRINTED PARTS (2 walls, 20% infill):

1x Base, Arm, and Bushing
2x Spacers

ASSEMBLY:

See diagram above.
Put M2 x 16 halfway into side of arm, capture one loop of spring with the screw and screw in all the way.
Slide bushing into arm (should rotate freely) then line up with holes in hinge (on Base print) screw M3 x 16 screws into both sides. You'll need to screw in both at same time to prevent bushing from rotating.
Insert spring into Base side hole, capture other end of spring with tweezers, insert m2x12 into spring loop and push screw into a slot.
Push dowel into Base. Put spacers on dowel as shown in diagram. The spacers won't need M2x12 screws for now, but PLA loses tension over time.
Screw onto wall with 4 wood screws (bottom 2 first)

Print Settings

Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
Low (I used 0.32mm layers)
Infill:
20% cubic
Notes:
- 2 walls.
- Arm is too big for any printer smaller than an Ender 3.

License

CC0

Wall-Mounted Paper Towel Holder
by Bonf is licensed under the Creative Commons - Public Domain Dedication license.

壁挂式纸巾架

朋友，你觉得上面这个模型，属于下面的哪个分类？

上面没有我要的选项

必须全中文，且长度不超过15

相关内容

猜你喜欢

联系我们

邮箱: 289047960@qq.com

最新模型

最热下载