工作台对齐支架

Bench Alignment Bracket

2023-07-27 06:45:26

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

In Model Railroading its common to need to align two benches so that the trackwork stays in alignment after rework, maintenance, etc. These brackets allow two separate bench frames to reallign with minimal effort with both X and Y alignment. Each side simply bolts to one frame.
By design it would be suggested to fasten one side on with the mounting screws but use temporary glue to hold the second one in place while aligning the benches. Once aligned and then the glue dries simply separate the benches and then fix the second bracket in place with screws.
The mounts are made to be fairly structural so that normal bumps and alignments should not break off the protruding edges. Edges are chamfered to allow the two benches to "self align" within reasonable tollerances as they are pushed together.

No special printing is needed as there are no supports and notice both sides are identical and can be mixed and matched.