SSP18红点对齐装置-铁架瞄准系统

SSP18 - Red dot mount - Iron sight

2023-08-06 09:28:40

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I have designed a red dot mount and a fibreoptic rear sight for the Novritsch ssp18.

The fibreoptic is not real and is only green 3d printing filament Petg that is glued in place in the holes. The holes a pre drilled before gluing inn the filament. I used a 2mm drill but use one that is the thickness of your filament or fibreoptic tube. The iron sights are printed in two parts and need a piece of wire, needle, nail or something similar in the right and left hole to hold the two parts together while gluing and for providing strength for the joint. The middle hole is for the screw to hold the sight on the slide. I sanded the parts lightly before gluing and used super glue to bond the parts together.

There is a short and a long version of the rear iron sight.

The 3d printed red dot mount is significantly lighter then the alu version that Novritsch makes and will reduce weight on the slide making it use less gas and cycle faster.

I used Pla for my prints but Petg and Abs/Asa should work. And for some of the prints i switched between .15 and .10 layer height.