WL玩具V950改装版

WL Toys V950 Mods

2023-08-20 18:29:08

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

WL Toys V950 helicopter mods as per YT video -
https://www.youtube.com/watch?v=jDN8mQqpB10

NB. All these will need fettling. I've had these on three V950s and they've all been slightly different.

Brace across chassis mounts. Pretty easy.
Tail fin. (Also fits 450 class). Needs the tail rotor motor mount drilling 2 x 3mm holes + nuts & bolts.
Tail rotor thing. Probably the hardest to fit. Remove rear rotor & push out shaft.
File the rotor shaft flat over longer length. Press the 'thing' over the drive gear. Glue and tap for small screw. Push onto shaft. Put it in place & tighten screw down onto the flat section of the shaft.
Boom support. Tap for 2 x 3mm screws. Relieve the inside of the brace to be flush with rear of chassis. Apply glue, put it all together and push to glue it tight on chassis. Clamp down onto boom with screws.
'Boom things'. (Not mentioned in video). When the boom is properly in place, drill through boom where the braces are clamped. MIND THE REAR MOTOR WIRES ! Bolt through using the 'things' either side.

See elsewhere on this site for the rotor head thing.

As there's some tapping & filing necessary I printed at 100% fill.

License

CC BY

WL Toys V950 Mods
by tl9481 is licensed under the Creative Commons - Attribution license.

WL玩具V950改装版

朋友，你觉得上面这个模型，属于下面的哪个分类？

上面没有我要的选项

必须全中文，且长度不超过15

相关内容

猜你喜欢

联系我们

邮箱: 289047960@qq.com

热门推荐

最热下载

ODCON1 3D打印枪壳（Gun4IR项目，NAMCO GunCon45风格）
2023-03-26
螺旋齿轮玩具3D模型
2023-03-26
通用型1/10比例底盘 - DKS基础款
2023-03-26
「春雷」弹壳弹出式泡沫飞镖发射器（进行中）
2023-03-26
Delta设置校准为Klipper
2023-04-23

最新模型