侧边载体5加仑桶版本3

Side Carrier for 5 Gallon Bucket - Ver. 3

2023-08-23 11:24:23

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This was something I made for a beach cleanup non-profit, Essence of Earth LLC. They had been manually separating cigarette butts from trash. They count and send them to a special recycling center that specializes in cigarette butts.

This is the third version I made for them after sending the second one and getting more feedback. They liked the single piece and the bucket design, but it was oversized. Most people don't collect more than 100 cigarette butts during their hour cleanups and this could probably hold a few hundred.

So I cut the width down to half. This saved a lot of material to print and I also thinned out the arms that hold onto the bucket. It is only thick in the areas that have the holes for the chopstick reinforcements. Those 4 holes on the arms fit bamboo chopsticks. Gluing chopsticks in the holes increases the strength of the pieces that hold onto the 5 gallon bucket. To be honest, I don't think they are really required anymore after testing, especially after reducing the size. But if you think you might have some serious weight in there then do it.

The piece is meant to be printed without support and should be printed with the bottom of the bucket pointing downwards. This is all based on my Ender 3 Pro.

I have continued to place the non-profit organization's name on the top of the bucket (Essence of Earth).