3D照片框装饰艺术

Picture Frame REMIX

2023-08-25 07:38:05

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I needed a frame for an odd 15" x 17" piece of glass, so I remixed this original model. Here's a list of some of the modifications made:

Cleaned up excess vertices
Created 7 mm inset for glass (assumed 2 mm) and backing
Split into corners and edge pieces for variable-size framing (short edge pieces = 160 mm, long edge pieces = 186 mm)

The different pieces are to be joined by 2 cm indexing rods clipped from standard 1.75 mm (PLA) printer filament. You will need 36 rods to complete this design.

In my GCODE files, you can see Cura's "fuzzy skin," which is a miracle worker for hiding layer lines. I kinda wanted my print to look something like wood. I also knew I'd need to do some manual sanding and glueing work at the end, so the fuzzy layers would make this more forgiving.

With my settings, only 2-3 of the overhang lines sagged away from the print. These were inconsequential to clip off and move on. Once again, the fuzzy perimeter makes this unnoticeable. Could probably solve the problem altogether using a wider nozzle and/or line width.

For my uses, I needed 4 corners and 4 of each of the long and short pieces. When combined with the corner pieces, this gives me an inner dimension of 15" x 17" (with just a few millimeters' wiggle room for the glass).

NOTE THAT THE "SHORT" AND "LONG" EDGES ARE NOT IDENTICAL! The shorter edge pieces have 1 end cutting one of the beading spheres in half. (This was the way to meet my needs with the fewest modifications.)