纳夫敌人扩展触发器模块

Nerf Nemesis rev trigger extender

2023-08-25 17:34:37

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a trigger extender based on the Out of Darts design but built from scratch. It is to accommodate microswitches when doing a rewire of your Nerf Nemesis blaster. There are two versions: "lockless" and "with lock."

"Lockless" resembles the Out of Darts version and requires you to remove the lock between the triggers that ensures you can't pull the main trigger without the rev trigger being actuated. I wanted to keep this lock to prevent jams if the wrong trigger is pulled so I designed the "with lock" version to fit around the lock. This is especially useful if you plan on lending the blaster to friends who aren't familiar with flywheel blasters.

You will need glue for both versions. Make sure to secure both the base and pin of the "with lock" version to keep it secure. I used hot glue and it works well. Print the lockless version with a brim and the lockless with supports.

Please note that the "with lock" version may be a touch too short. I put an updated "nubbed" version with a slightly longer, rounded tip that should be long enough. I personally printed the default version and put a dab of hot glue on the end to achieve the desired length. I recommend printing both and seeing which works best.

For use with: https://www.thingiverse.com/thing:6192108