18650接收器改装 Props3D IB-94 曼多布拉斯特模型

18650 Receiver mod for Props3D IB-94 Mando Blaster

2023-08-26 02:17:01

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I have a bunch of harvested 18650 batteries around and LiPo batteries and chargers aren't exactly cheap, so I tried to see where one might fit in here. There was almost enough space in the receiver for it. So I joined the top rail back on and hollowed it out to fit. There is a little bit of extra length to allow for adding connections to the battery as desired. I soldered mine. A single 18650 is not enough voltage so I used a USB battery pack charging board and put it in the handle. This will allow for charging the battery and the 5v needed to power the other boards.
I got some of these from aliexpress but they were only putting out the same voltage as the battery so, it must not have the boost circuit in it.
https://a.co/d/1Mep0Sz
I happened to have a board similar to this that I removed the USB-A from and connected the other parts to that lead.
https://a.co/d/eRi9kFa