诺夫里奇 SSE18 SSP18 前握式杂志适配器

Novritsch SSE18 SSP18 Front Grip Magazine Adapter

2023-08-27 08:29:34

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is an airsoft magazine adapter for the SSP18 Front Grip from Novritsch.

The front grip also fits the SSE18 perfectly, however, this front grip holds a spare SSP18 magazine but it will not hold an SSE18 magazine.

This adapter will allow you to use this front grip for SSE18 magazines.

Note: Will not hold the SSE18 extended 100 round magazines, but even if it could I would not do that because they stick out way too much and could easily be damaged, plus it'll look weird. lol

Please read the Post-Printing details and enjoy!

Print Settings

Printer brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.28 layers for faster print speeds.
Infill:
30
Filament brand:
Any
Filament color:
Any
Filament material:
PLA ,but PETG or ABS will work too.
Notes:
4 wall layers, 4 top and bottom layers.

Post-Printing

Sanding and screwing into position.

The front side of the mag adapter and the curved feed ramp should be sanded smooth for easier operation. Highly recommended! 220 grit works well. Only takes a few minutes.

Use a countersink woodscrew, drywall screw, or self-tapping sheet-metal screw. The length of the screw should be about 1.25 inches long, maybe 1.5 inches max. Do not use a screw any longer or it'll poke through the grip into the hand-guard area.
The open slot in front of the grip can be wedged open slightly with a flat blade screwdriver to insert the screw into the mag adapter hole. Use a handle-held screwdriver to drive it into the plastic and do not overtighten. This mag adapter is really hard to remove even without the screw installed, so the screw does not need to be very tight at all.
I used a countersink self-tapping sharp point T20 screw that was about 1.25 or 1.5 inches long. If you do not use a self-tapping or self-drilling screw then you may need to drill a small pilot hole first.

Use the cross bolt at the bottom front of the grip to adjust tension on the magazine.