经典款Raspberry Pi 5外壳（两块Snap Fit模块，无需螺丝或零件）

Summary

A retro case that's simple and functional. Designed for use with pi's active cooler.

I was aiming for a retro, Art Deco vibe, and also tried to capture the classic look of an RTX or Radeon reference GPU.

Print Instructions:

~38g of filament which takes my slow SOVOL SV06 four hours to print with:

.4 nozzle
.2mm layer height
I used various PLA filaments, but I don't see why you can't use something else that makes sense.
Print the models oriented with the most surface area facing down on the bed. No supports are necessary.
I use print bed glue to prevent any of the corners from warping, which happens to my machine sometimes.
If you want, print the top separately and set it for a filament color change at layer ~16 for that accent color effect! (see pictures)

Features:

Simple:

The case is only two pieces that snap together.
No supports, additional parts, or screws are needed.
Very minimal clean-up, if any.
Secure:

The pi should seat in nicely on the four pegs, but you may need to press gently on the pi around them to “snap” it in the first time.
There are two smaller pegs which provide an even base to prevent the pi from tipping toward its USB.
The lid holds the pi firmly in place on its pegs and minimizes rattling.
Sleek and Low Key:

Lid is flush with bottom and the case has a clean, understated look with no unnecessary contours.
My “logo” will be concealed by the pi once it is seated.
Functional:

Case allows for access to the IO pins from both sides, ribbon connections, SD card, as well as the power button and LED. You will probably need something to poke the power button in order to press it.
There is enough headroom to tape the RTC battery on top of the ethernet port (the best place I found for it so far).
Intended to be used with the official active cooler.
IO Versions:

There are versions with and without access to IO pins/ribbons. You can mix and match any top and bottom.

Additionally:

Opening the Case:

You may need to use fingernails, a flathead screwdriver, or similar tool to pry off the lid when taking it apart (by wedging it between the lid and case, then twisting).
Using Screws:

You can also (theoretically) cut off the top of the pegs and use screws/bolts instead - I purposefully allowed for this but have not tested it. You may need to use self-tapping screws and I did not test the size/depth of the underside's bolt recesses.

Future Versions:

Planned Changes:

I intend to shorten the USB side to be flush against the IO ports, eventually.
Pi 4 Compatibility:

If enough people request a Pi4 version, I can make one as well.

Known/Potential Issues:

The lid can be partially opened more easily than I would like on the USB side (but it will not open on its own). This is actually a benefit you when you want to remove the lid…
There is the potential for the case's protruding lip on the USB side to interfere with wider plugs (like USB sticks and dongles), but I don't think this is likely.
As mentioned above, the compatibility to use screws/bolts/nuts is theoretical.
Thermals are not tested. If anyone wants to record and provide them, I will upload the information.

I am continuing to make adjustments to the model, but I feel like its in a good place right now overall. If anything doesn't fit right, please let me know and I can see about adjusting the model. I am also open to other suggestions, if you have any.

If you'd like, please support my work by purchasing a physical print from me on Etsy!