简约风格的壁挂笔架
Simplistic Wall mounted pen holder
使用说明
- 所有模型资源均由用户上传分享，内容来源于网络公开资源
- 侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
- 模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们
关于费用
我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！
扫码手机访问
抖音私信 @jobsfan
Summary
The pen holder takes about 1 hour to print with 10% infill. It works with most pens, the pen I designed it around has a diameter of ~0.58 inches with a height of ~6.05 inches. A small 40-degree bevel holds the tip of the pen in place. Also, the lip opening allowing you to see the whole pen is ~0.382 inches wide so make sure the pen you use has a larger width than that.
To mount: I used sticky velcro strips to put on the wall/ pen holder.
Print Settings
- Printer brand:
ELEGOO
- Printer:
ELEGOO NEPTUNE 3 Pro
- Rafts:Doesn't Matter
- Supports:No
- Resolution:.25
- Infill:10
- Filament brand:
esun
- Filament color:
black
- Filament material:
pla+
- Notes:
This print takes about an hour with 10% infill with really any pattern. I haven't tested below 10% but I'm sure it can hold up fine.
License
Simplistic Wall mounted pen holder
by Gunnar3d is licensed under the Creative Commons - Attribution - Non-Commercial license.
相关内容
联系我们
热门推荐
-
2023年度EDC手镯饰品2023-05-10 -
星球大战3D棋盘模型：MrBaddeleys国际象棋棋子50%比例展示2023-08-24 -
侦察兵（分离结构化体模型）2024-01-16 -
3D无手模型2024-04-19 -
用于RRD通用型70182电机的mayrc maytech桅杆夹2024-04-20
最热下载
-
二十面体骰子模型2024-03-29 -
空客操纵杆配备控制杆固定装置2024-03-30 -
Arduino或5V继电器控制板固定架2024-04-02 -
Dyson V6系列3D模型适配器站2024-04-15 -
艺术雕像（女性）2025-07-16
最新模型
-
RAM 垂直式笔记本支架2024-05-08 -
宝可梦球隐藏2024-05-08 -
RC模型2024-05-06 -
法基尔2024-05-06 -
三菱迷你分体机遥控器2024-05-06