钟声导管

Bell Siphon

2024-01-06 01:40:36

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is my take on a bell siphon. This will install into a tray in which plastic pots are placed to be watered. The tray is flooded with water and will initiate a siphon when the water level gets above the thin ring (indicator line) on the outside of the bell siphon. As long as the water inflow rate is sufficient to fill the ouput tube, the siphon will be initiated. As long as the water can siphon faster than it is admitted to the container, the siphon will drain the tray. This is really intended for a watering tray which is filled by a timer and not a constant recirculating system like aquaponics.

There is a left-hand thread bung nut to connect the body through the tray bottom. This needs an o-ring seal between the body of the siphon and the tray. The bottom of the siphon body is threaded for 1/2" NPT threads (common 1/2" PVC plumbing fitting size).

This is intended to be printed with the output tube (tail) pointing towards the ceiling.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 v2
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Filament brand:
Polymaker
Filament material:
PETG
Notes:
I printed these at 240c. I designed the inside such that it printed well with this temperature despite having some overhead printing. I have printed slices of the most failure-prone areas and found that this design prints cleanly inside. I found that I was able to print these at 40mm/s with acceptable quality on my V2.