迷你型Raspberry Pi 5桌面箱配有冰塔散热器及底部NVME板

Mini Desktop Case for Raspberry Pi 5 with Ice Tower Cooler and Bottom NVME Board

2024-01-08 22:20:46

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a case for a Raspberry Pi 5 and (optionally) a second board attached to the bottom of the Pi with 6mm or 7mm long spacers.

The intended use is for the Pineberry Hat Drive!

https://pineberrypi.com/products/hatdrive-bottom-2230-2242-2280-for-rpi5

Probably also works fine with Pimoroni's NVME Base.

https://shop.pimoroni.com/products/nvme-base?variant=41219587178579

Basically there's a bunch of room under the Pi in this case. So other similar Pi accessories that mount below the Pi with 6mm - 7mm spacers/standoffs.

And it also (optionally) fits an Ice Tower Cooler by 52Pi.

https://52pi.com/collections/ice-tower-cooler-1/products/ice-tower-cpu-cooler-rgb-led-light-cooling-fan-for-raspberry-pi-5

The case has 2.5mm of extra room around the Pi board on the GPIO side, the HDMI side and more like 5mm of extra space on the SD card side - so there's room for ribbon cables or whatever else you need to connect the accessory board.

I wrote a little blog about this case as I built it.

https://imgur.com/a/LKGWowe

There's a version with little stubby legs.

There's a version with my typical SSD mount legs.

There's a version of the top and bottom panels that are just solid panels.

There's a version with grill openings that match the SD and USB side.

There's a version with designed infill that matches that SD and USB sides - if you're using filament that may permit a little light from the fan to show through the printed part, the infill pattern that shows will match the SD and USB side. This version is referred to as SKINNED.

All versions of the Top/Bottom panel require support material along the edges. I find that CURA and PRUSA slicers don't really support it to my satisfaction, so I designed my own supports. But there's also versions of the files with no support. If you use the supported version, they should be sliced at .24mm layer height.

The case is intended to be assembled with #4 self-tapping screws. 1/2" long.

Or you can use M3 screws, if you run an M3 tap through the holes before assembly.

The HDMI and GPIO side can be laser cut from 3mm acrylic or whatever material.