Sovol Filament Dryer SH01 - 导引丝

Sovol Filament Dryer SH01 - Filament Guide

2024-01-09 05:26:20

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a design for a Sovol SH01 Filament Dryer filament guide. I found when I tried to use this with my Ender 3 Pro I could not feed directly from the dryer box without it pulling the box sideways and inevitably breaking the filament or the dry box would fall over onto the ground. I decided to only utilize the filament roller on the left hand side of the dryer to feed into the machine. This design redirects the force on the filament over the bearing so that it easily pulls out of the dryer.

The filament dryer tower should be a snug friction fit, however, I would recommend adding a small piece of 3m double sided adhesive to both inside bottom legs to ensure the tower does not move. This should cause a very slight amount of bow to the legs and additional friction to the fit as well.

I already had 608 2RS ball bearings on hand so I designed this around them, you can order some for yourself here https://www.amazon.com/dp/B08XVFSZTF?ref=ppx_yo2ov_dt_b_product_details&th=1

I printed all pieces at one time, the orientation of the bolt is important to ensure that the M6 bolt included in the file stays together during use. Once the tower is up and on the dryer, friction fit the bearing inside the wheel and the spacer inside the inner race. When installing the bearing wheel onto the tower, ensure that the side with the lip to capture the bearing is on the outside. I don't believe this was truly necessary as the friction fit should be more than adequate, however, it gave me a bit of peace of mind to know that I captured the bearing from coming off externally in the event some strange failure happens with the wheel.