导线干燥机

Filament Drier

2024-01-16 05:43:20

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Remix due to being very hard for me to print in PETG. I printed 6 in PLA with little problem, but the deformed over the last year and i found some rolls of filament would drag the bottom due to the rollers being too far apart.

I also didnt care for the lose silica, and perfered the container built into the base of the stand.

Created and offset due to the taper at the bottom of the container. Can be scaled as needed.

These fit the rubber maid 21 cup food container, though they are getting harder to find.

Remix of https://www.thingiverse.com/thing:4976052

Part List from thingverse

01 Container

The dry box is built inside 21 cup Rubbermaid food container. I have a link to the container attached below. I recommend searching in different stores for the best price,and if you find the clear one it would look even better.
Container Link

02 Bearings

The design uses four 608 bearings, below are the cheapest ones I could find.
Bearings Link

03 Mini Hygrometer

After finishing all 9 of the prints I've realized that they have the white version of the same Hygrometer. Keep in mind that those are not the most accurate, so expect a margin of error.

04 Indicator Silica Gel

I like the indicator silica over regular silica, it's easier to know when you need to change it, although it's redundant since the design is using a Hygrometer.
Indicator Silica Link

05 PTFE ID-4mm OD-6mm

I used a tube with internal diameter of 4mm, this makes it possible to use the filament dry box with 2.85 (commonly referred to as 3mm) and 1.75 filaments.
PTFE tube Link