Ender 3 S1 同步带轮子

ender 3 s1 sync belt pulley

2024-01-18 09:15:11

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

the sync belt on my s1 seemed very loose and did actully skip so i designed this simple pulley (print 2 of each)
fix to top v rail next to breaing zrod block

addtinal parts
2x vslot nuts m4 (usualy have spares with enders )
2x m5 15mm bolts
2x m5 10mm bolts
2x small toothed ballraced pulleys

optional 2 small springs (recyled from a retractable pen would work)

assembly
m4 v slot in top rail fix the blocks next to zrod top blocks or where you like along this rail

fix the upright with the 15mm m5 through pully to the tube flat end dont over tighten the bolt will cut it s on thread lock the tube with plyers but dont over tighten should spinn free
lock the top of the tube into the rails on the block and use the 10mm bolt to tighten in again not fully should slide back and forth
(optional fit the spring between the 2 small spikes )
let the belt teens settle into the pulley slide forward to ension and tightn up
try to get both sides level and will take the slack out the sync belt

be gentle my 1st thing ive shared !