Nerf Rival 路由者 XXII-1200 泵式握把（带皮卡丁尼铁架）

Nerf Rival Pathfinder XXII-1200 Pump Grip with Picatinny Rail

2024-01-19 11:33:06

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This pump grip replaces the original so that custom foregrips can be attached.

It's still comfortable to use even without a foregrip installed.

Images depict the pump grip with the angled foregrip below:

https://www.printables.com/model/235802-angled-mini-foregrip

PRINTING:

Recommended to print with PETG for impact resistance.
Does not require supports if printed as oriented in file.
Requires good bed adhesion - consider adding a brim.
Requires decent bridge quality 
    Only at one spot near very beginning of print.

INSTALLATION:

Locate and remove all 6 screws attaching pump
Remove the pump
Locate orientation arrow on inside wall of 3D printed pump grip
    Arrow points towards nozzle, away from shoulder stock.
Snap new grip into place with arrow facing nozzle.
Replace the 4 screws that attach to the slider.
Finished - save the 2 unused screws as backups and print off a new foregrip!

TROUBLESHOOTING

If after installing the new part the pump gets stuck half way (i.e. wont fully retract or extend) you may need to remove a plastic stopper from inside the shell. This part can get easily dislodged or break when messing with the pump. It can be best to just remove the part entirely.

Lay blaster on a flat surface
Remove all screws holding shell together.
Remove the top shell half.
locate the little black spring loaded wedge piece (see images)
Remove entirely.
Replace shell and screw.

Please visit our Etsy shop to see what else we do!

https://kettlefishcreations.etsy.com