3D RC水上飞艇模型

RC Airboat

2024-03-21 00:40:42

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This project is an agile and speedy airboat designed with spare parts that I had laying around. Like most FPV pilots, I have a handfull of spare or broken parts laying around and I wanted to use on a watercraft design. After countless testing and hull re-designing I finally landed on what I think is a good balanced hull design. The hull is able to be taken up to full throttle and fully turned without capsizing or upsetting the hull too much. The airboat works with 2 tinywhoop motors/propellers and steers via differential thrust.

Much more information for this project can be found on the projects github page:
https://github.com/unixvoid/rc_airboat

Parts List

This is the list of parts specifically that I used on this project, it should be able to work with any whoop parts though.

Flight Controller: Happymodel Diamond F4 ELRS
Motors: 2x newbeedrone 0703 16420kv
Props: Gemfan 1610 biblade
Battery: Betafpv 300mah bt2.0
bit of velcro for battery strap
conformal coating

How to print

This project is broken into 3 printable parts, You will need to print one of each of these pieces to complete your airboat. I printed most of the hulls and the carrier in PLA with great success.
I also tried out lightweight PLA on a couple hulls which ended up absorbing water, so I recommend other materials unless you want to coat it after printing.

Hull (airboat_neo_hull.stl): This is the hull of the boat, print upside down with supports
Carrier (carrier.stl): This is the piece that slides into the hull and carries all the electronics. Print flat side down with no supports
Carrier Plug (airboat_carrier_plug.stl): This is the plug that fits behind the carrier, it helps push the carrier forward to balance weight on the hull and fills in the gap behind the carrier. No supports