超级赛车外星人头型滚丝架支撑架 FL SUN SR

Super Racer Alien head spool holder flsun sr

2024-03-23 23:04:04

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This has been working well for a while now. I should have printed the head at a lower layer height (might reprint). I printed the mounting section (where the screws go and a little bit of the spool portion) of the spool holder with full infill to stiffen it. I used a support blocker with custom settings (Cura), so it didn't print the whole spool holder at full infill. The holder plugs into the head. I used super glue on the inside. This was done in Fusion360. Brought in an alien head and made some changes to end up with this. Depending on your print settings, you may have to sand where it goes in a little, I made it very close for fit. It needs to be set flat on the bed because of its orientation in Fusion, it loads not flat. This is easy to do with the slicer. I hope you like it, let me know what you think please.