带边框的SCART连接器罩，配备M4螺丝孔，适用于RetroTINK-4K

Bracketed SCART connector shroud with M4 screw holes for RetroTINK-4K

2024-03-24 14:47:01

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

The RetroTINK-4K has a SCART input with threaded M4 screw holes for users to create solutions for secure connections, as modern SCART plugs are loose-fitting and prone to disconnection. This hood adds brackets with holes sized for M4 x 4mm x 6mm knurl nuts. M4 screws with a thread length of 10mm will secure the plug. The bottom half of the shroud has chambers for two M3 x 6mm x 5mm knurl nuts.

This plug was designed as a replacement for the bulky metal shrouds of the KabelDirect SCART cable, with a cable diameter of about 11.3mm. The M3 countersink screws from the original shroud can be used here. If countersink screws are not available, common M3 bolts can be used.

The angled connector pieces place the cable at a 20 degree angle, but heat-setting the M4 knurl nuts or installing a screw beneath the cable may be difficult. The straight pieces are recommended if this is a concern.

Print Settings

Printer brand:
Anycubic
Printer:
Kobra Max
Rafts:
No
Supports:
Yes
Resolution:
0.2
Notes:
Supports are needed for the large external screw thread, but should not be needed for the screw holes in the brackets.