Hole Calibration + M3 nuts + Hex holes

2024-03-28 11:24:31

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Calibration parts for calibrating horizontal expansion and hole horizontal expansion.

I prefer the HE_*.stl parts due to quick print times and low filament usage.

Calibrating horizontal expansion:

Measure the outside of the model ... The value is positive if the measurement is too small, negative if the measurement is too large
HE_14mm_10mm.stl:
- HE = (14 - Measurement) / 2
HE_10mm_6mm.stl:
- HE = (10 - Measurement) / 2

Calibrating hole horizontal expansion:

Measure the inside hole of the model... The value is positive if the measurement is too small, negative if the measurement is too large
HE_14mm_10mm.stl:
- HHE = (10- Measurement) / 2
HE_10mm_6mm.stl:
- HHE = (6- Measurement) / 2

M3 Nut Test (M3_Nut_Test.stl):

Intended for use after calibrating HE and HHE. Use it to verify an M3 nut fits snuggly into a recess.

Hex Wrench Test (Hex_Wrench_Test.stl):

Intended for use after calibrating HE and HHE. Use it to verify the hex holes are adequately sized to allow something (hex wrenches in this case) to easily slide in and out.

Old Hole Tests:

Hole_Test_3.stl: