头部追踪案例：Arduino Nano 33 BLE

Head tracker case. Arduino Nano 33 BLE

2024-03-30 03:13:05

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Case for Arduino Nano 33 BLE headtracker
Set button / reset hole/ USB / Power

Immersion RC power connector 5Pin
Used the NANO pin holes but cut the + pin to put a diode in between.
Because of the multi pin connector also Reset pin/ +5V out and A1 are connected to it.
No need to but was more stable.

3.5MM audio connector. Only soldered the tip and ground of the stereo connector but made a loose wire underneath just incase.

Button 12x12mm tactile with LED.
connected to the 3.3V output using a 47-86 Ohm resistor. (also depending on color)

Print Settings

Printer brand:
Creality
Printer:
Sermoon D1
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
100%
Notes:
Case for Arduino Nano 33 BLE headtracker
Set button / reset hole/ USB / Power

Immersion RC power connector 5Pin
Used the NANO pin holes but cut the + pin to put a diode in between.
Because of the multi pin connector also Reset pin/ +5V out and A1 are connected to it.
No need to but was more stable.

3.5MM audio connector. Only soldered the tip and ground of the stereo connector but made a loose wire underneath just incase.

Button 12x12mm tactile with LED.
connected to the 3.3V output using a 47-86 Ohm resistor. (also depending on color)