干衣机单页发射装置

Dryer Sheet Dispenser

2024-04-01 20:49:12

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Hai!!

Are you like me, and constantly have junk all over every horizontal service of everywhere in your house? My solution is to wall-mount EVERYTHING!! I'm sick and tired of a basket of laundry knocking my box of dryer sheets off the side of my clothes dryer and behind other stuff. I could declutter, I could sort the closet...

but I've got a 3D printer and ADHD, so I'm going to use the tools I have.

Anyway, what was I talking about?

Right!

This bottom-dispensing unit fits about 175mm by 110mm sheets, and the full model is 200mm high, holding about 400 (bounce) sheets. My little Kobra Neo had a failure halfway through and it didn't complete, but even a half-print works fine!

The full model takes 125.63mm of filament, 374.70g. My little guy would have taken 10hr37 to print the whole thing. I used 3 wall loops, 5% adaptive cubic infill, 0.32mm layer height, and 0.3mm first layer. Oh! Combination Infill, as well.

No supports needed, I'd print it with a 10mm skirt, and a good dollop of hairspray to ensure good bed adhesion.

Take it, print it, sell it, remix, whatever. I just wanna give back to the community that's given me so much.

Hope you like it!