无后盾Tux（代表Linux的企鹅形象）

Supportless Tux (Linux Penguin Mascot)

2024-04-03 02:17:54

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Fully printable without supports! I chose to use a brim for my prints, but it is not strictly necessary. Mine used 10% infill in a Gyroid pattern in PLA+ at 0.1mm layer height, scaled so it is 100mm tall (around 4 inches) and 2 walls / perimeters. At those settings, it only consumes 38 grams of filament.

Have fun!

Differences of the remix compared to the original model

I made the bottom flat for better adhesion and to make it set better on flat surfaces. I also added a tiny bridge on each flipper at its lowest point to connect it to the body and/or feet so the printer doesn't try to print mid-air. Minor geometry change to upper lip / edge of beak to prevent printing mid-air.