Drybox材料穿过结构

Drybox filament pass through

2024-04-04 01:57:56

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Filament Drybox Pass-Through

Does not require a pneumatic coupler
Accepts a 6mm OD PTFE or other plastic tube.
Minimum filament and time required to print (I print it in about 15 minutes on my Ender 3 V2)

This is a pass-through for a DIY filament dry box. It accepts a 6mm OD ptfe tube. Doesn't have to be ptfe, almost any tubing, hose, or line will work if its the right size. PTFE may be preferable if you intend on running it in an enclosure and your health conscious, but again not necessary.

The 6mm OD tubing presses in until it will go no further and is sufficiently held in place.
Some boxes are brittle so it is sometimes best to melt the right size hole to fit the threaded piece through. A sharp knife or razor blade works just fine unless its a cheap or old box. Some will practically shatter.

I'll add more to this later when I have time. Pretty straight forward and simple design though. I was going to do a full guide on how I build my dry boxes but there are hundreds already out there and mine isn't much different.