Endeavor 5机械箱3D模型

ender 5 enclosure

2024-04-06 06:11:19

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Simple enclosure I've designed with OpenSCAD and built myself.
There are surely better designs out there, but I wanted to try to project and build one.
To build print 8 x ender5enclosure.stl in PETG (or any not flammable material which can resist to heat like PETG or better).
Cut 11 x 2,5cm diameter PVC tubes each long 54,4cm.
Cut 5 x 60cm x 60cm radiator insulating foil sheets (check on the specs that they are not flammable).
Fit the tubes in the sockets (flat part of the 4 lower ball joints goes towards the floor, vice versa for the 4 up ball joints it goes to the ceiling).
Screw the tubes with 22 x M3x25mm wood screws (the front lower tube has sockets and screw holes but don't put yet, it will be removable door to better slide the printer in).
I've attached the foil to the frame with kapton tape (rated up to 280c).
The built enclosure should roughly be a cube of 62cm lenght per side.
For the door/window I've bought a 50cm x 50cm large and 4mm thick polystyrene transparent glass.
Cut another 2,5cm diameter PVC tube long 54,4cm and made a 50cm long (4mm thick) cut on one side to fit the window.
Then I've cut 3 pieces of radiator insulating foil of this sizes: 1x 11cmx60cm, 2x 6cmx60cm, and stitched around the window.
Then stitched velcro on the sides of this window borders with staples and on the receiving side of the enclosure with zip ties.