微型飞行实验室无线遥控舵机系统配置

MicroFlightLab RC servo setup

2024-04-06 17:16:43

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Small test bench for adjusting servo travel directions and simple motor setup.
This small bench was inspired by "RC video review": https://www.youtube.com/watch?v=1S74TF4YutQ&t=1086s

I started from scratch to make it more general-purpose, practical, and just as easy to print.

All moving parts clip together.
Cable management is facilitated by reusable clips.
Everything prints without supports.
A 'standard' layer thickness of 0.2 mm is sufficient.
The printing parameters are standard.
Optionally ensure that the infill is at least 25 or 30%.
It is advised to print the parts that clip together in PETG to take advantage of flexibility.
The cradles are designed for micro servos. The tolerances are generous.
The motor cradle is intended for motors of about 30 mm.
The rear stabilizer can be T or V-shaped.
A very good flight controller is required to make it fly (joke).

Designed in Sketchup.
.
.

Print Settings

Rafts:
No
Supports:
No
Resolution:
0,2
Infill:
25 - 30%
Notes:
It is advised to print the parts that clip together in PETG to take advantage of flexibility.