2022 Jeep Compass磁吸手机支架

2022 Jeep Compass MagSafe Phone Mount

2024-04-07 22:05:57

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This may be a remix, but mostly used this as a starting point. I had to do quite a bit of redesigning to make this work in my Jeep. Other than a bunch of minor size tweaks, I also "hollowed out the inside". One other major change i made was to the magsafe charger mount itself. No offense to the original maker but I could not get my charger to fit in the cutout, I opted to use this version instead

https://www.thingiverse.com/thing:4647550 (so thanks to this maker if you ever see this)

I did not include a full version because I could not get this to print good at all with supports (or non) with every attempt, therefore I split in two. Also you will of course need to buy an official Apple Magsafe charger.

These are my suggestions, feel free to go your own route.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 v2
Rafts:
No
Supports:
No
Resolution:
2.0
Infill:
15%
Filament brand:
SUNLU
Filament color:
Black
Filament material:
PETG
Notes:
Print instructions. (Everything without supports)
1. Print top section on its side-This will more thank likely have a few areas where it doesn't look the cleanest due to lack of supports, but it will be covered up with Charger anyway.
2. Print bottom section upside down-This will print pretty clean
3. I would not glue the two pieces as I think it will be impossible to fit the piece in the area after (go ahead and try).
4. Buy a package of hook & Loop (Velcro)
5. Cut strips and place all around the side (see pictures)
6. Place bottom section in car and push down all the way.