RV废物管道延伸装置

RV Waste Hose Carrier extension

2024-04-08 00:48:05

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

My RV trailer came with two waste hoses that could be connected together. The tube meant to carry the waste hose under the trailer was about a foot too short to carry both. While I have yet to need both hoses if they both get soiled I don't want to be carrying them in the same area with "clean" items. This is a simple extension tube that adds almost 6 inches to each side to allow both waste hoses to be carried in this one carrier tube.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 S1
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
15
Filament brand:
Elegy
Filament color:
black/white
Filament material:
pla

Post-Printing

After Printing

It should fit snugly in your current tube but it needs to be bonded if you expect it to stay. I used a high strength adhesive. I also coated the area where it joins with resin with the hope this would further strengthen this potentially weak point. I doubt any of this is necessary as this should come under little stress unless it gets hit by some large road debris on the road.but I worry a lot about failure in my designs.

The cover isn't complete to allow easy visualization of the tube in place.

I also have added a bungie cord across end to reinforce this not coming off on the road.

The large end cover doesn't slide through my tube. The outside edge is beveled to allow it to fit in the end.

RV废物管道延伸装置

朋友，你觉得上面这个模型，属于下面的哪个分类？