Creality Ender V3 KE 线圈转移配件套装

Creality Ender V3 KE Filament Spool Relocation Kit

2024-04-08 07:48:55

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I made this kit to allow a person to remove the heavy spool from the top of the 3D printer and relocate it to the side. This kit reuses the stock spool tower so that you can always quickly and easily go back to mounting a spool or partial filament on top if you wish. Changeover takes 30 seconds. I have 3 versions of these parts.

1) Made for 6mm plastic tubing - I didn't have any PTFE tubing so I used some nylon water line that I had in my basement. this works surprisingly well, but the PTFE is definitely better.

2) A version that accepts the quick connect bowden tube connectors (mine were from an old 3D printer and had a thread size of just under 6mm. These are the same connectors from an Ender 3 V2.

4) a version that should just accept the bowden tube directly, although I have not test fit this.

The side guide snaps tightly onto the side rail. It's a very tight fit, and I have found that they best way to do it is to get the rail into the outside edge of the clip first, then snap the inside edge around the rail. it should be nice and secure. The center guide is made to screw in place of the original spool holder, allowing you to use the factory mount for the filament sensor and keep everything lined up as it came from the factory.

Print the side clip in the install position.

Print the center guide with the threads facing down using supports and then just peel away the support from the threads.

Print the nut with the flat side down, using supports and peel the support out with a pick or sharp object. you may be able to print this without support, but I didn't test that out.

I am attaching the Fusion360 f3d files as well in case you want to modify or make another version.