FuzNuz 马蹄角度测量仪

FuzNuz Hoof Angle Meter

2024-04-16 16:43:17

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Measures to the nearest degree, The notch on the top represents every 10 degrees and then the hole that lines up the best gives the digit past the last 10 marker notch. The hoof slope will be 90 degrees minus your measurement, so if you measure 41 degrees on the meter then the hoof slope will be 49 degrees.

To assemble you will need some glue or epoxy for the pin as well as some lubricating grease. Place bottom and top card together as shown in photo and verify they are aligned properly, apply grease along the long pin part and place the angle measurer onto the pin. Test that it rotates smoothly and easily, and if not clean pin and apply sandpaper to pin until smooth rotation is achieved. Reapply grease as needed. Clean excess lubricating grease and then apply a dot of glue into the depression in the end of the pin. Place cap onto the pin to finish assembly, making sure no excess glue contacts the angle measurer faces. Allow to cure before use.