Roborock E4 E5 台阶高度减少模块

Roborock E4 E5 Stepheight-Reducer

2024-04-18 19:45:04

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Clips to prevent Roborock Vacuum cleaner from getting stuck at steeper slopes like bar-chairs. Mount them close to the optical front sensors (those of which are used to prevent from falling down a stair and as seen on the photos) of the front bumper of the Roborock E4/E5. This should prevent the Roborock E4/E5 from taking to high slopes and getting stuck. I tested it on stairs too. The optical sensors should not be affected and the robot stops before falling. Nevertheless, I don't guarantee anything.

Try to lay one of the thin sides on the build plate. Then print 4 of em all together. as close as possible.

Printed with 65° Bed-Temp for first layer. Then reduce to 60.
Nozzle temp at 225° at the first layer. Then reduced to 215°.

Print Settings

Printer brand:
Flsun
Printer:
Flsun Super Racer
Rafts:
No
Supports:
No
Resolution:
0.1mm / 0.4mm Nozzle
Infill:
15%
Filament brand:
-
Filament color:
-
Filament material:
Tough PLA
Notes:
Try to lay one of the thin sides on the build plate. Then print 4 of em all together. as close as possible.

Printed with 65° Bed-Temp for first layer. Then reduce to 60.
Nozzle temp at 225° at the first layer. Then reduced to 215°.

Takes about 1h and 40min for 4 clips to print at 200mm/s speed.