SnapMaker 2.0 喷嘴清洁支架与排气托盘

Snapmaker 2.0 Nozzle Cleaning Mount & Purge Tray

2024-04-20 07:52:41

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A nozzle cleaner and purge tray mount for Snapmaker 2.0 machines. It was specifically designed for the A250 where both screw holes can be affixed to the underside of the bed framework with two screws, but should fit on the A350 with the use of a single screw (just make sure its screwed tight!).

Two STLs are included for the front left and right sides of the bed framework. Rotate the model 180 degrees along the X-Axis (my bad). Prints without supports. BOM at bottom of description.

See here for a demonstration: https://youtube.com/shorts/lwas6wnEwiY?feature=share

You will need to make adjustments to your starting GCODE to allow for the machine to position itself over the purge tray during purge, and brush itself against the wire brush with a hot nozzle. I've documented mine below as a reference:

///

; Start Cura G-code start script
M140 S{material_bed_temperature_layer_0} ;Set Bed Temperature
G28 ;home
G90 ;absolute positioning
G1 X-15 Y55 F3000 ;Move to corner
G1 Z0 F1800 ;Go to zero offset
M190 S{material_bed_temperature_layer_0} ;Wait for Bed Temperature
M104 S{material_print_temperature_layer_0} ;Set Hotend Temperature
M109 S{material_print_temperature_layer_0} ;Wait for Hotend Temperature
G92 E0 ;Zero set extruder position
G1 E20 F200 ;Feed filament to clear nozzle
G92 E0 ;Zero set extruder position
G1 X-15 Y-10 F3000
G1 X-15 Y75 F3000
; End Cura G-code start script

///

BOM: