通用卷盘托架 - 3D模型主页

The Universal Spool Holder - Main Page

2023-03-26 20:44:36

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

```html

This is the main page for my universal spool holder design... This page contains every single file I have made and every derivative of the holder... I'm going to lay out instructions on how to get the perfect fit for your spools in the instruction tab... You can also watch the YouTube video below where I explain everything you need to know...

https://www.youtube.com/watch?v=zG1CFx9aUIk&feature=youtu.be

There are three "sizes" (different length arms) for this spool holder... Every arm length is on this page in STL form, but to make it simpler and to avoid confusion, I made three separate pages for each sized holder (Small, Standard, Oversized)... When you watch the video or read the instructions you know what measurements to take to get the perfect fit... On a side note, if you want a truly, all around "Universal" holder - you can simply print two "OverSized" Arms and 110mm Rods... This will fit damn near every spool - it just wont be a tailored fit - and thus wont look pretty... This is why I decided to make three sizes - strictly for aesthetic reasons.

Small - http://www.thingiverse.com/thing:1001360
Standard - http://www.thingiverse.com/thing:943563
OverSized - http://www.thingiverse.com/thing:1001359

This is a full redesign of my popular, but old and relatively weak spool holder that I designed nearly two years ago...

Old, Obsolete Spool Holder:
http://www.thingiverse.com/thing:290064

This new design is 100% better - I completely redesigned my screws and spinner bolts for better tolerance for 3D Printing... My old screws were good if they were machined, but they were way too fine to be 3D printed well... So I made the threading much better and made the screws much stronger... I also added a lot of structural features that I explain in the video...

Here's a list of what I did in the new design.

Made both arms (the base and the spinner) 2.5mm shorter in height, I also added fillets to every corner so every contour is nice and rounded.
Redid the bolt pattern and made that easier on the hand while spinning the spinner bolt.
Increased the diameter of the screws and added 45 degree chamfers for strength... Screws are now much stronger.
Infill is not a big issue... 15-20% should do it... If you want everything to look nice on the outside - do 3 perimeter shells.

Other than all of that - this should work for everyone and will fit on 95% of spools... The only spool I know doesn't fit on this univeral holder is Taulman brand spools... But never fear, I made a spool holder specifically for Taulman Spools...

You can find the Taulman spool holder here... http://www.thingiverse.com/thing:938437

I hope you find this spool holder useful... Thanks for reading... ENJOY!!!