巴斯卡科罗拉多3-9倍x40抛物线调节器

Barska Colorado 3-9x40 Throw Lever

2024-05-01 06:36:24

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Designed a throw lever for a Barska Colorado 3-9x40 scope. I use this with aDaisy 880 shadow. I've created 2 versions for people to use, as I noticed the length of the lever was close to touching the stock end, SEE IMAGESALSO, Please read below for info

https://www.amazon.com/dp/B00359T1Z8

It uses an M4 nut and M4x25mm socket head screw. I made the wedge part really thin so it acts like a hinge when opened to install. I imagine if you flex this excessively, it will sever the print. I think it has about a 1mm strand, that is about 8-10mm tall. You'll have zero issues if you leave it on the scope, but constantly removing it might be a problem. Printing it in PETG, rather than PLA might also make it last longer.

There will be a small gap when it is installed between the 2 hinged parts down by the bolt, this is normal. I had to design this in such a way that it could be tightened with a strong grip without falling off of the scope ring it mounts on. Originally, when I made it an exact fit, it would slip off so I had to change the radius to make it smaller so it could clamp tighter, hence the small gap.

Print Settings

Printer brand:
Prusa
Printer:
i3 MK4
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.2 (PLA) or .25mm (PETG)
Infill:
40%
Filament brand:
Prusament
Filament color:
Orange
Filament material:
PETG
Notes:
Infill doesn't matter too much, 40-100% is good. I think I did 3 outlines, 4-5 top and bottom solid layers, .25mm tall layer height. You can use organic supports if you wish by the nut area. I did, but it's probably not necessary because it's so small in there for a bridge in the print.