LoveSac模块化鞋底替换

LoveSac Modular Shoe Replacement

2024-05-03 22:31:38

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I adore my LoveSac couch BUT the cats kept losing their small toys in that scant 1 inch space under it and I could never get them back. So between the need to clean underneath the couch and a desire to regain my under couch storage, I needed a way to increase the couch leg height. Additionally, my under couch storage drawers needed a bit more space than was provided inbetween the standard LoveSac shoes.

This design allows you to not only have a wider space between full shoes, but also to not have to print full shoes in those spots where you don't need a full shoe. Only have two feet next to each other? No need to print all four spots then! In testing, this design is still fully supporting the couch, even when only using one of the pieces.

I needed almost 6 inches, but wanted more flexibility down the road if I get rid of the drawer storage, so I split the design into 75mm heights.

The LoveSac Shoe Initial Height pieces have flat bottoms, while the LoveSac Shoe Additional Height files have a small foot extended down to make sure it seats into the initial layer.

Additionally, if using only one height, there are connectors and empty slot fillers for the full height. But if using more than one layer, I found using the 50mm connectors and fillers added structural support to the connections between the layers.

I also had one corner where we didn't have an arm so I needed only one piece but didn't want the slots to be visible, so added the Single FaceFrame model to cover over the connection points.

Print Settings

Printer brand:
Bambulabs
Printer:
Bambu X1C
Rafts:
No
Supports:
Yes
Resolution:
0.16
Filament brand:
iSANMATE
Filament color:
Ebony
Filament material:
Wood PLA
Notes:
The initial height, connectors, and empty fills don't need support. Only the additional height model was printed with supports, but it may not need it as the internal opening is not seen.