推力主管T16000M 200mm扩展

Thrustmaster T16000M 200mm Extension

2023-03-26 12:26:52

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

I designed this as a 200mm extension for the Thrustmaster T160000M joystick. It works very well as an extension of the stick however the twist axis is limited so its best to use rudder pedals. The twist will work somewhat if you twist it by the extension vs the joystick grip but its not perfect.

You need to print two halves and one of each insert to complete the extension. It is designed to have a gap between the halves when tightened to allow it to be tight against the joystick shaft while allowing room for the wires and loose tollerances of cheaper printers. You will need five screws and four nuts (I used 1.5" #6-32 screws). The extra screw goes into the extension as added support for the extension where the handle attaches. Thats it no extra parts just screws and nuts.

This extension is fully reversable and does not make any permanent modifications to the joystick.

推力主管T16000M 200mm扩展

朋友，你觉得上面这个模型，属于下面的哪个分类？