Ender 3 S1 防拖拽跑出传感器支架

Ender 3 S1 Run-out Sensor Bracket

2023-05-12 10:46:58

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I tried a number of the various runout sensors out there and they all seemed overly complex, or required additional hardware, or located the sensor in a location that didn't make sense to me... so I designed one that did.

This slides into the C channel on the gantry on the Ender 3 S1.

Simply disconnect the runout sensor and take off the spool holder. Unscrew the runout sensor from the spool holder. Use that screw to secure the runout sensor and bushing to this bracket. Tighten until the runout sensor doesn't rotate freely and unscrew one half turn (or until the sensor moves freely).

Remove the two screws holding the crossmember of the gantry to the vertical supports and slide this in to your desired location on the gantry.

Put the screws back into the crossmember.

Viola.

Let me know if you confirm that this bracket works for other printers so that I can update the list. I suspect this will work on any printers in the Ender 3 series, but I don't have access to any other printers to confirm that suspicion.