xTool D1 Pro 蜂巢式脚夹板和支撑架

xTool D1 Pro Foot Brackets and Honeycomb Risers

2023-03-26 13:56:35

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

xTool D1 Pro 安装套件

I developed this kit to help mount my xTool D1 laser cutter to a sheet of MDF. These parts were designed to work with #8 Truss Head wood screws. The riser corners separate the protective aluminum panel on the bottom from the honeycomb panel above, allowing better airflow when using the air assist kit

Kit Includes:

Foot brackets for the add-on risers (print 4)

Note that these will not work with the standard D1 feet without at least one set of risers attached
Remove the rubber bumpers on the bottom of the legs before installing

Riser blocks for the honeycomb work panel

Separate STLs are provided to accommodate the corner with the rivet
For a single honeycomb setup, print one rivet riser, and three standard risers
For a double honeycomb setup, print two rivet risers, two standard risers, and two divider risers

Drill guides are provided if you want help aligning and pre-drilling holes in your mounting board

By lifting the honeycomb panel, there may be a bit of flex if you will be cutting or engraving heavy materials. Consider adding an additional support under the honeycomb if you experience flexing that causes the laser to lose focus. The riser lifts the honeycomb panel 22mm above the aluminum protection panel's surface.

xTool D1 Pro 蜂巢式脚夹板和支撑架

朋友，你觉得上面这个模型，属于下面的哪个分类？