Siphon起始器 7-20毫米管道

Siphon starter 7-20mm tube

2023-07-22 18:18:42

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Should work with any tube diameter 7-20mm

UPDATE:
Made pet bottle threads instead of you having to mess with the bottle cap a bunch. Should work much better but I can't test it for a while so I'll leave the old version too just in case. If you only screw a bottle in it may not be water tight, in which case it should function mostly the same however leak if stored upside down.

For the updated one, just screw the bottle on and:
Fill the pet bottle with water and screw on the siphon starter.
Hold the bottle under water with the other hand pushing the tube end down onto it by hand to make a temporary seal, with the connecting point being under water.
Squeeze the bottle and push all air out the other end of the tube.
Remove the bottle from the tube and let go to make it suck in water from the reservoir and refill itself.
It should now be flowing by itself as long as the end of the tube is below the water level in your reservoir.

The video I used for the thread measurements: https://www.youtube.com/watch?v=-BS9KR-B9U4

For the old version:
Drill a hole in the cap of a pet bottle and glue the cap in the slot on the siphon starter.

Contraption can be stored upside down without leakage.