3dsjs

索尼70-350mm镜头外壳

Sony 70-350mm Lens Collar

2023-08-24 05:50:55

使用说明

  1. 所有模型资源均由用户上传分享,内容来源于网络公开资源
  2. 侵权投诉:通过抖音私信 @jobsfan 联系我们(需附版权证明),24小时内处理
  3. 模型将通过邮件发送(5分钟内自动发货),感谢理解带宽压力
关于费用

我们是爱好者共建社区,为维持服务器成本,每个模型收取微量费用(仅覆盖基础开支)。我们承诺最低成本运营,感谢您的支持!

扫码手机访问
抖音私信 @jobsfan

Summary

IMPORTANT!! PRINT AND USE AT YOUR OWN RISK!!
Please understand that this is a cheap piece of plastic that will be used to hold at least 1k worth of equipment. Use at your own risk.

I saw that lens collars for this specific lens are about $50, so I made my own. This is designed for a Sony E 70-350mm f/4.5-6.3 G camera lens.

The 'tripod quick shoe' mount was designed with a Fotopro tripod in mind, but the screw hole on the bottom is just a standard 1/4-20 thread, so it might be able to fit others.

The whole thing is tightened by a 1/4" replacement knob I found at Lowe's, which is linked below. You will need some washers as well, I linked the ones I used.

Don't tighten the ring to tight btw :)

Print Settings

  • Printer brand:

    Creality

  • Printer:

    Ender-3 v2

  • Rafts:
    Yes
  • Supports:
    Yes
  • Infill:
    at least 40%
  • Filament brand:

    Inland

  • Filament material:

    PETG

  • Notes:

    PETG is recommended for its strength and UV resistance. Print with flat ring face down. Supports are recommended because it will ensure that the 'tripod shoe' will have a good fit.

Parts List

Knob, 1/4-20 threading: https://www.lowes.com/pd/Hillman-Replacement-Knobs/4757889

Washers: https://www.lowes.com/pd/Danco-10-Pack-1-2-Rubber-Washer/3380002

Slip a washer on the knob before putting it in the part, this will allow the ring to be tightened.

Tags

License

CC BY-NC

Sony 70-350mm Lens Collar
by Grantt is licensed under the Creative Commons - Attribution - Non-Commercial license.

索尼70-350mm镜头外壳
朋友,你觉得上面这个模型,属于下面的哪个分类?
必须全中文,且长度不超过15

相关内容

猜你喜欢