轴向SCX6 - 岩石灯饰

Axial SCX6 - Rock Lights

2023-08-26 23:05:54

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Here is my take on rock lights for the SCX6. These have been out crawling and tested so I’m good with releasing them for everyone!

You’ll need to do some printing, drilling and soldering so be prepared.

Printing:

You’ll need to print all the items included along with a total of 4 screw retainers; if you want to use washers that’d work as well; you’re just making sure you don’t get a pull through.

Assembly - Front:

You’ll want to use the template provided; I’d do the screw holes first, then use screws to hold the template piece while you use the larger drill bit (3 holes and some hobby knife work will do it) to make the hole for the light to shine through.

Assembly - Rear:

Again use the template provided and make your holes.

Wiring

Starting from the driver-front pod you’ll want to get measure out wires to the rear driver-side pod. Then wires from that driver-rear to the passenger-rear pod and then back up to the front-passenger. The front-passenger also gets an extra lead to plug into your 3S battery. My suggestion would be to do all your wiring, test it and the move to install.

Assembly - Final

The LEDs should slide in from the top, and should be pretty easy. The rears, you need to put the LED strip through the hole first, then slide it into the holder.

Parts:

LEDs

4 x 25mm sections of 5054 120LED/m 12v strip (reference here)

Screws - Front
2 x M3 x 10mm (cap or flat head)
2 x M3 lock-nuts

Screws - Rear
2 x M3 x 8mm (any type)

Drill Bits: