RC无裙式飞行器 - 单电机稳定管道设计

RC Skirtless Hovercraft - Single Motor Craft Stability Duct

2023-09-07 17:36:23

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Stability port duct with anti-torque vanes as used on my single motor build.

This suits a 3548 motor, 10" propeller and 6mm base foam. The motor beam cutouts are 20x10mm on one side and a bit higher on the other to accommodate the motor wires. It's easy enough to cut them larger.

Info:

The lower 6mm of the duct is ~1.6mm thickness to support itself in the foam. The wall dimension is the thickness of the rest of the duct. Print at 0.4mm if possible, every gram counts.

The exact amount of curve in the vanes to counter the residual torque is a trial and error process. You may find a plain (no vanes) duct is actually alright. Excessive curve will cause rotation in the direction of the propeller.

I use the "Mid curve 0.4mm walls" on my build as shown on my 2023 design summary. If you need less curve than this but more than none, I would advise removing a few of the vanes. I can't practically upload dozens of curves.

If you need the "Max curve" vanes I would suggest you have an issue with air leaking from the rear flaps or something. It is far too much on any of my builds. As before if you need less than this but more than the mid curve, cut out some of the vanes.

Once you have the correct curve, this can be glued permanently in place.

Print Settings

Printer brand:
Anycubic
Printer:
i3 Mega
Rafts:
Yes
Supports:
Yes
Resolution:
0.2
Filament brand:
RS PRO
Filament material:
PLA
Notes:
Print upright. Supports advised for the motor beam cutouts.

Raft advised - brim or skirt may work but not certain.