Ender 3电源保护罩修复方案 - 角度垫片

Ender 3 PSU Fix - Angled Shim

2024-01-09 07:08:23

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

On my ender 3 I have the PSU cover that moves the power lead to the back of the PSU, there was enough clearance initially but it has caught the rear right levelling wheel a few times, knocking the bed out of level and was hitting the glass bed so i designed this quick shim to just angle the psu away from bed slightly. its only 2.5mm but it appears to be enough. ill change it if it needs more angle.

You need to print TWO of these, one for each of the bolts that hold the PSU on!

i rotated it in cura so it printed laying flat on the bed, it will probably print fine on its side though.

Print at 25% infill (i also printed at 0.2 layer height to make a smoother shim)

Screw the bolt through the frame and the shim then line up the psu and screw it all together, keeping the shim in place with your finger while tightening, ensuring the thick part of the shim stays on the side closest to the bed.

If the hole is a little tight, just screw the bolt through the hole and turn it a few times and it will loosen but will be a nice tight fit.

Print Settings

Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Resolution:
0.2
Infill:
25
Filament brand:
SUNLU
Filament color:
Black
Filament material:
PLA+
Notes:
Any PLA will do. Print two of these at 25% and including a brim should only take about 20 minutes on an ender 3